Fisker Buzz Forums banner

1 - 20 of 40 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter · #1 ·
I have acquired about 200 new Fisker parts from a dealer at cost or below. I have a master list and am looking for help in listing and selling the parts. I can scan and email the list to anyone interested.
 

·
Premium Member
Joined
·
484 Posts
Do you have a black plastic part that covers the seat bottom where the seat adjustments are for the driver side?
 

·
Premium Member
Joined
·
3,063 Posts
Steven I may have that? Do you have a part number? Maybe you can get a number from the dealer?
Don't count on having that they were never available separate from the seat. Have to try and find a used one that's what I had to do when I needed one
 

·
Premium Member
Joined
·
484 Posts
Don't count on having that they were never available separate from the seat. Have to try and find a used one that's what I had to do when I needed one
Harley Guy,
Do you know the part number for the whole seat in black leather / black fabric combo?
 

·
Premium Member
Joined
·
484 Posts
I have acquired about 200 new Fisker parts from a dealer at cost or below. I have a master list and am looking for help in listing and selling the parts. I can scan and email the list to anyone interested.
Hi cmauro9, looks like I do not have a part number for a Drivers Side Black Hard Plastic Seat Panel. If you come across one, please let me know. Thank you.
 

·
Registered
Joined
·
886 Posts
@steven
Just being curious... Where/why/how did you lose your plastic part?
 

·
Premium Member
Joined
·
484 Posts
@steven
Just being curious... Where/why/how did you lose your plastic part?
Hi Stefan,
I was approaching the drive up window at my bank. I was worried I might scratch the wheels, so I drove too far away. I unbuckled my seatbelt to sit near the edge of the seat to reach, when I heard a cracking noise. The plastic cover over the seat controls cracked. I'm only 155 lbs. What made matters worse is that I scratched the rims on the other side.
 

·
Registered
Joined
·
886 Posts
Oh, i feel sorry for this.
If you could take the plastic off, wouldn't it be possible to glue some supporting material at the inside? In that case it would only look scratched.. Until you could find a part...
 

·
Premium Member
Joined
·
484 Posts
Oh, i feel sorry for this.
If you could take the plastic off, wouldn't it be possible to glue some supporting material at the inside? In that case it would only look scratched.. Until you could find a part...
Hi Stefan, good advice... I've been thinking I'd try that using lots of epoxy. Just haven't had the time. It also doesn't look horrible, just loose.
 

·
Registered
Joined
·
42 Posts
I'm needing the cover for the charging port. Do you have one? Also, please send me the list of other parts, ie. floor mats. Thanks.
 
1 - 20 of 40 Posts
Top