Fisker Buzz Forums banner
1 - 12 of 12 Posts

· Premium Member
Joined
·
491 Posts
I...phone 6S Bluetooth will not pair with the car...
I've had no problem pairing my new iPhone 6s, it worked first try. It just took me a few seconds to realize where the verification code was displaying.

BTW, I use the Bluetooth only for podcasts and GPS because there is always an echo for the person on the other end of a phone call.
 

· Premium Member
Joined
·
4,665 Posts
I have been using the original Iphone 6 for a few months. The biggest problem is that the phone is now too big for the cup holder and I had to come up with a different solution for keeping it in place, but the BT works about the same as the Iphone 5s and 4s.

The trick to reducing the echo is to reduce the volume on the phone to the lowest setting possible without muting it and using the volume control on the steering wheel to adjust the volume to a usable level. This is a bit tricky because you can only adjust the volume during a call, but once you set it, it tends to stay there. There are still occasional crackles, but at least you don't have to listen to yourself talk when you do this.
 

· Deep Ocean in ATL
Joined
·
436 Posts
It is possible that Icediggity is following the original pairing instructions which do not work after one of the SW upgrades (I think 503).

I would have to go through procedure again, and don't recall verbatim after pairing my Galaxy 5 Note.

If someone recalls, please post for IceD. Otherwise I will try to go to car and repair mine.
 

· Registered
Joined
·
889 Posts
iPhone 6s works fine for me (beside the poor call audio quality).
It paired without problems on 520

Fab, I like, the way, it does not perfectly fit into the cup holder. With my cover, it goes half way into the holder. I can see more of the screen and the power cable does not kink.
 

· Premium Member
Joined
·
4,665 Posts
iPhone 6s works fine for me (beside the poor call audio quality).
It paired without problems on 520

Fab, I like, the way, it does not perfectly fit into the cup holder. With my cover, it goes half way into the holder. I can see more of the screen and the power cable does not kink.
The cover comes from griffin. Rubber frame and transparent plastic on the back.
The rubber keeps it in the cup holder.
My cover must have a larger bumper around the edge and does not fit into the cup holder at all. I am using
instead. It almost perfectly covers the clear plastic cover over the battery and very securely holds the phone in place. even during spirited driving.

I miss seeing the battery light show, but the Disco PRNDL effects make up for that.
 

· Premium Member
Joined
·
3,089 Posts
The problem with 520 and some CIU problems causes the car to lose backup camera and presets and NAV the CIU needs to be reflashed with 510 only the CIU . The fault doesn't show up right away can take a week or two to happen .
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top