Fisker Buzz Forums banner

Module test bench

937 Views 0 Replies 1 Participant Last post by  Harleyguy
Not sure if this has ever been posted this is the test equipment Joe and myself use in order to charge and discharge High Voltage Modules .We test them before they are installed in the battery pack.If they don't charge properly on the work bench they won't work when installed . If the module doesn't charge above 24.0 Volts its more then likely has a bad cell . Doing this on the bench gets us a little closer installing a good module .
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.