Fisker Buzz Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
Hi guys.
I'm constantly working to eliminate the problem with the brakes after repairing the brake master cylinder.
An error is displayed C12FE - Description dependent on the manufacturer.

The problem is that when I turn on the engine, the brake pedal is hard, after a while the pedal enters and brakes are not. Then a message appears on the display.
Can U help me?
 

·
Liked, but not well liked
Joined
·
1,172 Posts
Hi guys.
I'm constantly working to eliminate the problem with the brakes after repairing the brake master cylinder.
An error is displayed C12FE - Description dependent on the manufacturer.

The problem is that when I turn on the engine, the brake pedal is hard, after a while the pedal enters and brakes are not. Then a message appears on the display.
Can U help me?
This is boost pressure lost probably because you did not bleed the system- you need the fisker scan tool to do that
 

·
Registered
Joined
·
21 Posts
Discussion Starter · #3 ·
Thank You for re. It's possible only in Fisker Service or
s there a non-original diagnostic scanner available? I have a 1000 km to the nearest fisker service....
 
1 - 3 of 3 Posts
Top