Fisker Buzz Forums - View Single Post - Stearing linkage repair
Fisker Buzz Forums

View Single Post
Old 04-06-2018, 02:18 PM   #14 (permalink)
Harleyguy
Senior Member
 
Join Date: Mar 2012
Location: South Florida
Posts: 2,975
Mentioned: 141 Post(s)
Tagged: 3 Thread(s)
Quoted: 485 Post(s)
Default

Quote:
Originally Posted by Nazc0 View Post
Its not a bushing issue, It uses a ball joint at the end. The part is relatively inexpensive and easy to install. I would suggest doing both sides while you are at it as the car will need an alignment afterwards.
Your information is in correct you can not just replace the ball joint on the lower control arms . Also the problem is the bushings on the lower control arm wear out. You have two choices replace both control arms or buy a set of bushings Alex Pop has made and press out the old ones and press in the new ones. As far as out and inner tie rods if the other ones are worn out you buy just the other tie rods. If the inner ones are worn out you need to buy a complete steering rack or find a set of good used ones. Fisker never produced the inner tie rods or sell them separate.
This post had two separate discussions concerning front end problems
Harleyguy is offline   Reply With Quote
 
Powered by vBadvanced CMPS v3.2.3

All times are GMT -4. The time now is 12:37 PM.



Powered by vBulletin® Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.